EPA Method 1

EPA Method 1 does not directly match ALS - Columbia's list of currently available methods. Please call for availability.

Method information displayed is provided for informational purposes only. No warranty (express or implied) is made as to the website accuracy, completeness, or applicability (such as the age of a method and whether or not it applies to your project). Please contact us for assistance.

View Actual EPA Method 1 (PDF File)


EPA Method 1:
SAMPLE AND VELOCITY TRAVERSES FOR STATIONARY SOURCES

Summary:
This method is designed to aid in the representative measurement of pollutant emissions and/or total volumetric flow rate from a stationary source. A measurement site where the effluent stream is flowing in a known direction is selected, and the cross-section of the 183 stack is divided into a number of equal areas. Traverse points are then located within each of these equal areas.

Scope:
The purpose of the method is to provide guidance for the selection of sampling ports and traverse points at which sampling for air pollutants will be performed pursuant to regulations set forth in this part. Two procedures are presented: a simplified procedure, and an alternative procedure (see Section 11.5). The magnitude of cyclonic flow of effluent gas in a stack or duct is the only parameter quantitatively measured in the simplified procedure.

Report Number:
520/5-84-006

Date Issued:
8/1/1994

	Examples:	8260 TO-15
	Examples:	Dioxin Mercury

<-- Search All Test Methods



Suggestions? The test methods page continues to expand and improve. If you have suggestions for improvement, we would enjoy hearing from you. Please contact the webmaster here.