EPA Method 6010-C


EPA Method 6010-C does not directly match ALS - Columbia's list of currently available methods. Please call for availability.


Method information displayed is provided for informational purposes only. No warranty (express or implied) is made as to the website accuracy, completeness, or applicability (such as the age of a method and whether or not it applies to your project). Please contact us for assistance. Analytical testing dots

PDF IconView Actual EPA Method 6010-C (PDF File)


EPA Method 6010-C:
Trace elements in solution by ICP AES. Official Name: Inductively Coupled Plasma - Atomic Emission Spectroscopy (ICP-AES)

Summary:
This method describes multi-elemental determinations by ICP-AES using sequential or simultaneous optical systems and axial or radial viewing of the plasma. The instrument measures characteristic emission spectra by optical spectrometry. Samples are nebulized and the resulting aerosol is transported to the plasma torch. Element-specific emission spectra are produced by a radio-frequency inductively coupled plasma. The spectra are dispersed by a grating spectrometer, and the intensities of the emission lines are monitored by photosensitive devices.

Scope:
Inductively coupled plasma-atomic emission spectrometry (ICP-AES) may be used to determine trace elements in solution. The method is applicable to all of the elements listed below. With the exception of groundwater samples, all aqueous and solid matrices require acid digestion prior to analysis. Groundwater samples that have been prefiltered and acidified will not need acid digestion. Samples which are not digested require either an internal standard or should be matrix-matched with the standards. If either option is used, instrument software should be programmed to correct for intensity differences of the internal standard between samples and standards. Refer to Chapter Three for the appropriate digestion procedures.

Citation:
SW-846 Online: Test Methods for Evaluating Solid Waste, Physical/Chemical Methods

Interferences:
I. SPECTRAL INTERFERENCES: (1) Background emmission or stray light. (2) Spectral overlap of emissions.II. PHYSICAL INTERFERENCES: High viscosity or high particulate levels of sample can clog nebulizer.III. CHEMICAL INTERFERENCES: (1) Compound formation. (2) Ionization. (3) Solute-vaporization.IV. MEMORY INTERFERENCES: Carry-over from sample.

QC Requirements:
(see ch. 1), CB, MB, ICV, CCV, MSD

Maximum Holding Time:
See SW-846 Chapter Three for information.

Media:
VARIOUS

Subcategory:
Inorganic

Concentration:
None given.

Precision:
Data from an EPA round-robin Phase 1 study. Seven participant laboratories applied the ICP technique to acid distilled water matrices that had been spiked with various metal concentrates. The data is taken directly from Table 4 of the method. NOTE: Not all laboratories reported results for all analytes. For example, only two laboratories reported results for selenium.

Detection:
Estimated instrument detection limits at monitoring wavelengths specified in Table 1 of the Method.

Revision Number:
Revision 3.0, November 2000

Analytical testing dots


Examples:  8260
TO-15

Examples:  Dioxin
Mercury
Analytical testing dots


<-- Search All Test Methods



Suggestions? The test methods page continues to expand and improve. If you have suggestions for improvement, we would enjoy hearing from you. Please contact the webmaster here.


Analytical testing dots